OSHA 10-HOUR GENERAL
INDUSTRY COURSE

• In the OSHA 10 Online Course General Industry, students must score at least 70% in each module to open the following Safety Training module. Every student will get up to THREE attempts to pass every module test.
• The final exam of the OSHA 10 hours General Industry course consists of 40 questions, and the student needs to score at least 70% to pass this course. Again, each student will get to THREE attempts to pass the exam. Upon successful completion, the learner will get a Department of Labor Card.
• In case of failure, the session will end. Yet the student can repurchase and start back from the beginning.

NOTE: COMPLETE THE SURVEY AT THE END OF THE TRAINING TO RECEIVE YOUR DOL CARD

Understand the OSHA Act and its functions and resources.
Become aware of the OSHA inspection priorities and understand the inspection process; know the rights and responsibilities of employers and employees under the OSH Act;
Understand the hazards associated with slips, trips, and falls on walking and working surfaces; effective egress and fire protection programs; flammable and combustible liquids and gases; chemicals; electrical equipment; personal protective equipment usage and limitations.
Understand the general requirements for general safety standards.

• OSHA Outreach Training Orientation
• OSHA 10-Hour Learner Responsibilities
• Introduction to OSHA (US)
• Personal Protective Equipment (PPE) Overview for Construction: Protective Characteristics
• Personal Protective Equipment Overview for Construction: Using and Maintaining PPE
• Struck By, Caught Between – Staying Out of the Line of Fire
• Excavation and Trenching Safety
• Concrete and Masonry Awareness
• Fall Protection (US)
• Aerial and Scissor Lifts
• Ladder Safety for Construction (US)
• Scaffold Safety Awareness
• Slips, Trips and Falls for Construction
• OSHA 10-Hour Midway Progress Report
• Crane Operator Safety
• Basic Rigging Awareness
• Material Handling Practices for Construction
• Stacking and Storage Practices for Construction
• Electrical Safety for Construction: Cord and Plug Connected Equipment
• Electrical Safety for Construction: Power Lines and Lockout/Tagout
• Hand and Power Tool Safety for Construction
• Hand, Wrist and Finger Safety
• Preventing Cuts and Puncture Wounds
• Hot Work for Construction
• Confined Space Awareness for Construction
• Hydrogen Sulfide (H2S) Awareness
• Hazard Communication
• Health Hazards in Construction
• Dust Mask – Voluntary Use Guidelines
• Heat Stress
• OSHA 10-Hour Wrap Up